ASTM B(). Standard Specification for Nickel Plate, Sheet, and Strip. standard by ASTM International, 10/01/ View all product details. Manufacturer & suppliers of Nickel / ASTM B Plate Aesteiron Steels leading Nickel / ASTM B Plate manufacturers, founded in Buy ASTM B() Standard Specification for Nickel Plate, Sheet, and Strip from SAI Global.
|Published (Last):||15 December 2008|
|PDF File Size:||9.55 Mb|
|ePub File Size:||9.27 Mb|
|Price:||Free* [*Free Regsitration Required]|
ASTM B162 Alloy 200 / 201 Strip Plate and Sheet Suppliers
The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. Cutting is used to separate large sheets into smaller pieces, to cut out a part perimeter, or to make holes cavities in a part. Link to Active This link will always route to the current Active version of the standard.
This abstract is a brief summary of the referenced standard. Deep drawing is a manufacturing process that is used extensively in the forming of sheet metal under tensile and compressive conditions, without altering the sheet thickness.
Looking for some more information?
ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date. For deep drawing and spinning quality sheet and strip, the material shall conform to specified values for grain size and hardness properties.
Test methods chemical analysis, mechanical test, grain size test shall be performed in accordance to referenced ASTM documents itemized herein. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM B – 93ae1 Standard Specification for Nickel Plate, Sheet, and Strip
Offer on Fasteners Sitemap. Siddhagiri Metals and Aatm Manufacturer: Sheet metal parts are characterized by high strength, good dimensional tolerances, good surface finish, and relatively low cost. G162 material shall conform to the mechanical property requirements for tensile strength, yield strength, elongation, and Rockwell hardness. In plate products, this can be achieved by controlling the finishing temperature in hot rolling and the elimination of the anneal that follows hot rolling.
The material shall conform to the chemical requirements for nickel, copper, iron, manganese, carbon, silicon, and sulfur.
Siddhagiri Metals and Tubes Rating: These sheets are made by rolling process. The material shall be uniform 1b62 quality and temper, smooth, commercially straight or flat, and free of injurious imperfections.
Sheet and Strip can be cold rolled to higher strength. Also Each flat rolled product owes its final properties not just in the rolling process itself but to its vital interactions with the preparatory steps of asm, casting, scalping and pre-heating; intermediate annealing; and such later finishing steps as a solution heat treatment or final annealing, stretching, leveling, slitting, edge trimming and aging.
Historical Version s – view previous versions of standard.
AlloyAlloy Brand: It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application.